0:00
hi I'm Steve Garrett from the Corvette
0:02
Today podcast the only current podcast
0:05
dedicated to a Corvette at
0:08
www.corbetttoday.com today I'm going to
0:11
be installing the frunk surround done in
0:14
carbon fiber by American hydrocarbon
0:17
I'll get a little closer so you can see
0:19
the weave but it is absolutely gorgeous
0:21
it looks fantastic and I'm going to be
0:24
installing this today first off I'm
0:27
taking off the side pieces and these all
0:29
just pop out and they're just done with
0:32
Clips so I'll be doing that on both
0:34
sides first before I remove the top and
0:38
I'm using a prying tool that I have that
0:41
I got here at one of the car shows I'm
0:43
just popping this up and this should pop
0:55
next up is the big piece the big main
0:58
piece here and again if you just use
1:00
your prying tool you can get underneath
1:02
here and pop this off
1:05
once you get the ends off the rest is
1:07
pretty simple it just pops up
1:12
the final piece is this front piece and
1:16
again if you just pull it out and then
1:18
pull it up everything should pop right
1:36
all right I have the big main piece in
1:38
place now and now it's just a matter of
1:41
putting the clips back down
1:52
next up I'm going to put this front lip
1:55
piece in and over here all you do is
1:58
tuck it in underneath
2:01
there's a lip under there
2:03
tuck this underneath as well
2:07
there it goes and just pop into place
2:19
next up are the two side panel pieces
2:21
and these just slide into place and then
2:27
and here's the final P look it looks
2:30
absolutely gorgeous again thanks to
2:32
American hydrocarbon Pat scorsetti over
2:35
there does a phenomenal job and this
2:37
looks absolutely outstanding
